Movement finesse issues?

[Jayegg]

So, you know how when you move your piece to the edge, you can spin it to make it move a block or two off the side? well, the first time i turn it, it doesnt move a block to the left or right and stays there. I have to turn it back and re-turn the piece for it to actually move of the edge. Am i doing something wrong?


I am using Jstris.

Sorry if this seems like a dumb question.

[caffeine]

Check with the wiki guide: https://harddrop.com/wiki/0G_60_Hz_SRS_Movement_Finesse

What piece, what wall, which rotation? Are you sure you're completely letting go of the left/right button before rotating?

[Jayegg]

Check with the wiki guide: https://harddrop.com/wiki/0G_60_Hz_SRS_Movement_Finesse

What piece, what wall, which rotation? Are you sure you're completely letting go of the left/right button before rotating?

Ok, well ive tried rotating the pieces again, but for some strange reason i have to let go of the piece and wait for a second,  before i can actually move it off the edge.

[caffeine]

Check with the wiki guide: https://harddrop.com/wiki/0G_60_Hz_SRS_Movement_Finesse

What piece, what wall, which rotation? Are you sure you're completely letting go of the left/right button before rotating?

Ok, well ive tried rotating the pieces again, but for some strange reason i have to let go of the piece and wait for a second,  before i can actually move it off the edge.

I'm not sure I understand. The sequence should go sometime like:

• Press and hold the "move right" button.
• Wait for the piece to hit the wall.
• Let go of the "move right" button.
• Rotate.

Is that what you're doing? Are you sure you're letting go of the move button completely before pressing the rotate button?

[Jayegg]

Check with the wiki guide: https://harddrop.com/wiki/0G_60_Hz_SRS_Movement_Finesse

What piece, what wall, which rotation? Are you sure you're completely letting go of the left/right button before rotating?

Ok, well ive tried rotating the pieces again, but for some strange reason i have to let go of the piece and wait for a second,  before i can actually move it off the edge.

I'm not sure I understand. The sequence should go sometime like:

• Press and hold the "move right" button.
• Wait for the piece to hit the wall.
• Let go of the "move right" button.
• Rotate.

Is that what you're doing? Are you sure you're letting go of the move button completely before pressing the rotate button?

Never mind, turns out im actually just stupid and i was unconsciously holding down the move button when i rotated... Sorry for wasting your time